monzana Miza Manual De Instrucciones página 5

Do not allow water or other liquids to get into the appliance. Do not
expose it to rain.
Do not use the appliance if the plug, the mains cord or other
components are damaged.
If the mains cord is damaged, you must have it replaced by a
service center authorized or similarly qualified persons in order to
avoid a hazard. Otherwise there is a risk of electric shock. Never try
to repair the appliance yourself.Never plug in or unplug the mains
plug when your hands are wet.Avoid pulling the cord when removing
the plug from the socket. Instead, hold the plug. Make sure that the
mains cable is not squeezed, bent, damaged by sharp edges or put
under mechanical stress. Avoid excessive thermal stress on the
mains cable from extreme heat or cold. Do not modify the mains
cable. Otherwise the mains cable may be damaged. A damaged
mains cable can cause a deadly electric shock.This device is not
intended for use by persons (adults and children) with physical,
sensory or mental impairments or lacking experience and/or
knowledge of use unless they are supervised by a person
responsible for their safety or have received instructions from that
person on how to use the applicator. Children should be supervised
to make sure they do not play with the device.
WARNING! Do not tighten the screws completely until the product
has been fully assembled. If you do tighten them completely at an
early stage, significant problems could occur during the further
assembly of the product.
Maintenance and care
Switch off the lamp, disconnect the plug and allow the light bulb/lamp to cool down completely. Only
wipe them with a damp cloth. Clean the lamp without aggressive cleaning agents, cleaning alcohol or
other chemical solutions. This can damage the case or even affect its function. The LEDs are
permanently installed and cannot be replaced.
Commissioning
1.
The lamp has a USB port, which must be connected to a suitable adapter
(not included).
2. The lamp is controlled by a switch on the cable. Three brightness levels
can be selected:
a. After pressing the " "switch, the lamp is switched on with a
brightness of 10%.
b. Pressing again increases the brightness level to 40%
c. After the third press, the lamp reaches the full brightness level
5