Technical Data - LD Systems AMP 106 T Manual De Usuario

TECHNICAL DATA

Item number
Product type
Line inputs
Line input connectors
Line outputs
Powered outputs
Cooling system
Priority levels
Input Section
Nominal input sensitivity
Nominal input clipping
THD+N
Frequency response
Input impedance
SNR
SNR (best conditions)
CMRR
Gain
Connector
Standby wake up threshold –30 dBu
3rd Party Control
Main volume
Power standby
Amplifier output
Type
Amplifier outputs
Connector
RMS output power
Peak output power
Frequency response
High pass filter
Protection
14
LDAMP106T
Installation power amplifier
2
balanced line inputs, pitch 3.81 mm terminal block (3-pin)
0
1 with output mode selector (LO-Z / HI-Z)
Convection cooling
1
8.5 dBu (sine 1 kHz, gain max)
18 dBu (sine 1 kHz, gain 0dB)
< 0.02% (SPK OUT, 4 dBu, 20 kHz BW)
20 Hz – 20 kHz (LO-Z SPK OUT, –0.5 dB)
12 kohms (balanced)
> 100 dB (SPK OUT, 8 dBu, gain max, 20 kHz BW, A-weighted)
> 102 dB (SPK OUT, +13 dBu, 22 kHz BW, A-weighted)
> 48 dB (SPK OUT, 4 dBu 1 kHz)
–33 to 18 dB
2 x 3.81 mm terminal block 3-pin
10k (linear taper) External potentiometer, pitch 3.5 mm terminal block (3-pin)
External momentary button, pitch 3.5 mm terminal block (2-pin)
Class D
1-channel, mono summed, LO-Z: 4 ohm minimum load, HI-Z 70 V or 100 V outputs
4-pin terminal block (pitch 5.08 mm)
60 W (continuous sine wave 1 kHz, 4 ohm load)
72 W (100 msec sine 1 kHz burst @ 4 ohm load)
15 Hz – 20 kHz (LO-Z, –1 dB)
20 Hz – 20 kHz (HI-Z, –1 dB)
110 Hz
Over/Undervoltage, Overtemperature, Short-Circuit, DC-Detection