Instructions For Use; Inserting/Replacing The Battery; Eco Mode; Switching On And Off - Flex CL 5000 10.8 Instrucciones De Funcionamiento Originales

Instructions for use

WARNING!
Before any work on the device, pull out the
battery.
Before switching on the power tool
Unpack the device and accessories and
check that no parts are missing or were
damaged during transport.

Inserting/replacing the battery

 Push the charged battery into the device
until it engages fully.
 To remove, press the release button (1.)
and take out the battery (2.).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; there is a risk
of explosion and fire!
14
CL 5000 10.8/18.0 / CL 10000 10.8/18.0
Battery state of charge
 Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.

ECO mode

The battery-powered LED work lamps are
equipped with a reminder function for low
battery power. After flashing three times, the
lamp switches automatically to ECO mode
with a lighting output of 300 LM. There is
enough time to change the battery.
In ECO mode, the brightness indicator
flashes.
– By pressing and holding the brightness
down button, the lamp can be manually
switched to ECO mode for the longest
period of operation possible.
– Pressing any random button cancels ECO
mode as long as the battery power is
sufficient.

Switching on and off

 Switch the battery-powered LED work
lamp on and off by pressing the on/off
switch.