Draper RC/FSL/10W Manual De Instrucciones

These are the original product instructions. This document is part of the product; retain it for the life of the product, passing it on to subsequent holders. Read
this manual in full before attempting to assemble, operate, or maintain this product. Always use the latest version of the product manual. The latest version can
be downloaded from drapertools.com/manuals
1. Specification
Stock No. Part No.
03182 RC/FSL/10W
03183 RC/FSL/20W
03185 RC/FSL/30W
EU 04347 RC/FSL/20WFOB
This light is rated IP65. It is fully protected against dust and is protected
against low pressure jets of water from all directions (limited ingress
permitted). This does not include the attached plug.
2. Health and Safety Information
Important: Read all Health and Safety instructions before attempting to
operate, maintain or repair this product. Non-compliance with these
instructions may result in injury or damage to the user or the product.
Draper Tools accepts no responsibility for improper use of this device.
• Inspect the product and electrical connections for signs of damage or
battery leakage before every use.
WARNING! Do not use the product if defects are present and
withdraw it from service until it has been repaired. If the external
power cable is damaged, it must be replaced by suitably qualified
personnel or returned to Draper Tools for repair.
• ONLY the supplied adaptor should be used to charge this product; DO
NOT use the adaptor to charge other products or batteries.
• DO NOT use the charging adaptor if wet.
• Always ensure that the voltage rating on the charging adaptor is
appropriate for the power supply to be used.
• Remove all packaging and wrapping before use.
• Position the product appropriately.
− Use only on level surfaces.
− Ensure that the product is stable and unlikely to tip over.
− Where necessary, apply weights to the stand or secure it.
− Ensure that all joints are securely fastened when the product is in
use or stored.
− This is a Class III appliance and should only be used with the
charging adaptor supplied.
• WARNING! This product gets hot when in use.
− NEVER place objects on the lamp area or hang objects on any part
of this product.
− NEVER use the light near flammable or combustible substances or
equipment.
− ALWAYS disconnect the power supply and allow at least ten minutes
for the product to cool before attempting any maintenance or
adjustment.
• WARNING! Do not stare at the operating light source.
• ALWAYS ensure that the light is switched off during charging.
− Keep trailing cables and extension leads tidy and secured to avoid
trip hazards.
RECHARGEABLE
FOLDING
SITE LIGHT
Bulb wattage (W) Lumens (lm)
10
1,100
20 2,200
30
3,300
20
2,200
USB output Beam angle (°)
5V, 1.5A
100
5V, 1.5A 100
5V, 1.5A
100
5V, 1.5A
100
Risk of electric shock
Class III product, use only with the
charging adaptor supplied
− This product is certified for use in ambient temperatures of 0 to
+40°C.
− Replace any cracked protective shield.
− This product includes a 4mm glass shield rated IK08.
3. Maintenance and Troubleshooting
Important: Maintenance and repair, including replacement of the light
source, must only be performed by qualified personnel with sufficient
knowledge of the electrical circuits used in this device.
• Charge the product for at least six hours before first use.
• Always disconnect the power supply and allow the lamp to cool before
cleaning.
• Clean the lamp using a dry cloth ONLY.
CAUTION! Do not immerse this product in water.
• Store the product in a clean and dry environment, out of reach of
children, with all joints firmly secured.
• Charge the light fully before storing and at least every three months
between uses to maintain the battery life.
If the light does not illuminate when switched on, check the charge level.
Ensure that charge is retained when disconnected from mains power.
4. What's in The Box?
Carefully remove the product from the packaging and examine it for any
signs of damage that may have occurred during shipment.
(A)
A. Rechargeable folding site light B.
EN
Original Instructions
Version 1 – March 2022
Colour temperature (K)
6,000~6,500
6,000~6,500
6,000~6,500
6,000~6,500
Replace any cracked
protective shield
(B)
Stock No. 03182 shown
Power adaptor