HQ-Power VDPDMXDP152 Manual De Instrucciones página 3

Idiomas disponibles

5. Operating Instructions

Analogue Connection

Fix the device and put the circuit breaker at the back in the OFF-position. Connect the analogue

controller with the device via an 8-pin cable. Put the output of the analogue controller in the

minimum position. Connect the load on the SCHUKO output sockets.

When all connections are made, connect the device to the mains and turn on the circuit breaker.

Adjust the output of the analogue controller to adjust the corresponding load on the selected

channel.

DMX Connection

Fix the device and put the circuit breaker at the back in the OFF-position. Connect the DMX

device into the DMX chain by means of a 3-pin XLR cable. Connect the load with the SCHUKO

output sockets.

Define the DMX start address of the device by means of the DIP switches according to the table

given below :

The device can perform several functions, depending on the setting of the last DIP switch (n°

10). See table above for the different settings.

When all connections are made, connect the device to the mains power and turn on the circuit

breaker. Adjust the output of the analogue controller to adjust the corresponding load on the

selected channel.

Note that each channel has an output LED to show the actual status of the channel.

6. Fuse

Do not try to repair the device. You can only open the housing to replace a blown fuse with an

identical one.

Unscrew the cover of the fuse holder with a screwdriver, remove the old fuse, insert the new

one and close the fuse compartment again. Order spare parts from your local dealer.

VDPDMXDP152

Fig. 3

FUNCTION = FUNCTIE = FONCTION

any one of the DIP switches 1-9 is ON, DMX parallel

all the DIP switches 1-9 are OFF, auto parallel

any one of the DIP switches 1-9 is ON, DMX

all the DIP switches 1-9 are OFF, auto

DMX ADDRESS = DMX ADRES = ADRESSE DMX

start. address

512

VELLEMAN