KRESS Commercial KAC929 Manual De Instrucciones página 6

NOTE:The frame 1 and frame 2 should fit closely with the CyberTank mounting bracket. (The base frame
needs to be overlapped with the CyberTank mounting bracket)
There must be a certain gap between frame 3 and CyberTank.
Frame 2
Frame 1 Frame 3
EN
If your CyberTank has NOT been installed
- Read CyberTank installation guide
- Install the CyberTank
NOTE: Do not assemble the protective guards of CyberTank. For detailed information of CyberTank installa-
tion, please refer to CyberTank installation guide.
- Determine the CyberCabinet's installation position based on the location of your CyberTank either in your
truck bed or trailer.
- Place the cabinet base outline on the outside of your CyberTank.
NOTE: The line 1 and line 2 of the base outline should fit closely with the CyberTank mounting brackets.
NOTE: Please place the base in the correct direction. Do not confuse the front and back of the base out-
line.
- Drill the mounting holes (13 mm) into the truck or trailer as it shows on the base outline.
NOTE: See the above figures for the recommended drilling position of mounting holes.
- Place the base frame in the position shown in the figure above. Fix the base frame with carriage bolts and
nuts.
6