Revision Notices
Problem
Flashing YELLOW LED when
battery pack is inserted in the
charger.
Solid RED LED at any station
upon battery pack insertion.
Solid RED LED at any station
after charging is complete.
Solid RED LED at any station
after INITIAL charging is
complete.
Revision Notices
Revision A May 2003
Revision B March 2005
Changed word "operator" to "user". Updated LXE logo on front page, added statement about not
placing/storing the Multi-Charger in hazardous locations.
Revision C October 2005
Added WEEE statement to "Introduction".
Revision D November 2006
Updated equipment graphics to show new LXE logo, added Troubleshooting segment directed toward new
batteries. Added Accessories with ROHS classifications. Added Revision Notices.
E-EQ-MX5CHGROG-E-ARC
Cause
The battery pack is too hot or
too cold to charge.
If upon insertion, indicates that
the battery pack is the wrong
type chemistry, i.e. not lithium
ion.
If after end of rapid charge
period, indicates an error in the
battery pack's internal flash
memory.
New Battery Initial Charge
Completed -- Remove and
reinsert the battery. If the LED
remains red after 15-20 minutes,
this indicates the battery is
"bad".
Solution
Remove battery pack from the charger
and allow it to adjust to room
temperature.
NOTE: If the battery pack is left in the
charger, it will cool down or warm to a
temperature upon which the charger will
begin the charge cycle. However,
depending on the temperature of the
battery, it may take 2-3 hours to adjust.
The cool-down of a battery pack is much
quicker if the battery is not in the charger
pocket.
Replace battery pack with correct type.
Return the battery pack for service –
noting the failure mode.
Return the battery pack for service or
analysis – noting the failure mode.
MX5 Multi-Charger User's Guide
9
