Idiomas disponibles
Idiomas disponibles
EN
13
TROUBLESHOOTING
Problem
The machine does not start
when you push the trigger.
The machine stops when
you cut.
The line does not advance. Not enough line on spool.
The line keeps breaking.
The grass winds around
the trimmer head and mo-
tor housing.
The line does not cut well. The cut-off blade becomes dull.
Possible Cause
No electrical contact between the ma-
chine and the battery pack.
The battery pack is depleted.
The lock-out button and trigger are not
pushed at the same time.
The guard is not attached to the machine. Remove the battery pack and attach the guard to the
Heavy cutting line is used.
The grass winds around the motor shaft
or the trimmer head.
The motor is overloaded.
The battery pack or machine is too hot.
The battery pack is disconnected from
the tool.
The battery pack is depleted.
Lines are worn too short.
Lines are tangled on spool.
The machine is used incorrectly.
Cut tall grass at ground level.
English
Solution
1. Remove battery pack.
2. Check contact and install the battery pack again.
Charge the battery pack.
1. Push the lock-out button and hold it.
2. Pull the trigger to start the machine.
machine.
Use only with the nylon cutting line of 0.095" / 0.080"
(2.4 mm / 2.0 mm) diameter.
1. Stop the machine.
2. Remove the battery pack.
3. Remove the grass from the motor shaft and trimmer
head.
1. Remove the trimmer head from the grass.
2. The motor will recover to work as soon as the load is
removed.
3. When you cut, move the trimmer head in and out of
the grass to be cut and remove no more than 8" in pass.
1. Cool the battery pack until its function returns to nor-
mal.
2. Cool the machine for approximately 10 minutes.
Install the battery pack again.
Charge the battery pack.
Install more line.
Advance the cutting line.
1. Remove the lines from the spool.
2. Wind the lines.
1. Cut with the tip of the line, avoid stones, walls and
other hard objects.
2. Advance the cutting line regularly to keep full cut-
ting width.
1. Cut tall grass from the top down.
2. Remove no more than 8" in each pass to prevent
wrapping.
Sharpen the cut-off blade with a file or replace it.
14
