Tabla de contenido
Idiomas disponibles
Idiomas disponibles
All DMX-controlled devices need a digital start address so that the correct device responds to the signals.
This start address is the channel number from which the device starts to "listen" to the DMX controller.
Enter the correct number and read it from the display located on the base of the VDP3000ST.
You can use the same starting address for a whole group of devices or enter an individual one for every
device.
When all devices have the same address, all the VDP3000STs will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set different addresses, each device will "listen" to a separate channel number.
Changing the settings of one channel will only affect the device in question.
In the case of the 4-channel VDP3000ST, you will have to set the start address of the first VDP3000ST
to 1, the second VDP3000ST to 5 (1 + 4), the third to 9 (5 + 4) and so on.
•
DMX Control Modes
The DMX control modes are selected through DIP switches 1 to 5.
1-Channel Mode
o
The 1-channel mode allows you to use the whole flash range (0 ~ max.) and the blinder effect. Select
the 1-channel DMX mode by setting DIP switch 5 to ON.
3-Channel Mode
o
The 3-channel mode allows you to control the flash intensity, flash duration and flash rate for more
advanced control. Select the 3-channel DMX mode by setting DIP switches 1 ~ 5 to OFF.
4-Channel Mode
o
The 4-channel mode allows you to control the flash intensity, flash duration and flash rate for more
advanced control and offers a 4
mode by setting DIP switch 4 to ON.
16.03.2010
1
2
↓
ON
1
2
↓
ON
th
channel special pre-programmed effects. Select the 4-channel DMX
1
2
↓
ON
VDP3000ST
3
4
1-channel mode
3
4
3-channel mode
3
4
4-channel mode
5
5
6
5
6
5
6
©Velleman nv
Rev 01
Tabla de contenido
