Idiomas disponibles
Idiomas disponibles
FlexFan
Technical Data
Normal Environmental Conditions
This product is designed to be safe under the following
conditions:
• Indoor use
• Altitude up to 2 000 m
• Operating temperature °C / °F to °C / °F
• Storage temperature °C / °F to °C / °F
• Maximum relative humidity 80 % for temperatures up to
31 °C / 89 °F decreasing linearly to 50 % relative humid-
ity at 40 °C / 104 °F
• Mains supply voltage fluctuations up to ±10 % of the
nominal voltage
• Transient overvoltages up to the levels of overvoltage
category II
• Temporary overvoltages occurring on the mains supply
• Pollution degree 2
• Ingress protection rating:
Declarations
EU DECLARATION OF CONFORMITY
We, Atlas Copco Industrial Technique AB, SE-105 23
STOCKHOLM SWEDEN, declare under our sole responsi-
bility that the product (with name, type and serial number, see
front page) is in conformity with the following Directive(s):
2006/42/EC, 2011/65/EU, 2014/30/EU
Harmonized standards applied:
EN 61000-6-2:2005, EN 61000-6-4:2007+A1:2011, EN
61010-1:2010, EN 61010-2-201:2013, EN 61326-1:2013
Authorities can request relevant technical information from:
Aleksandra Duric, Product Compliance Manager, Atlas
Copco Industrial Technique AB, SE-105 23 Stockholm Swe-
den
Stockholm, 21 November 2022
Carl von Schantz, Managing Director
Signature of issuer
WEEE
Information concerning Waste of Electrical and Electronic
Equipment (WEEE):
This product and its information, meets the requirements of
the WEEE directive/regulations (2012/19/EU), and must be
handled in compliance with the directive/regulations.
The product is marked with the following symbol:
© Atlas Copco Industrial Technique AB - 9834 4757 00
Products marked with a crossed-out wheeled bin symbol and
a single black bar underneath, contain parts that must be han-
dled in compliance with the WEEE directive/regulations. The
entire product, or the WEEE parts, can be sent to your "Cus-
tomer Center" for handling.
UK DECLARATION OF CONFORMITY
We, Atlas Copco Industrial Technique AB,
SE-105 23 STOCKHOLM SWEDEN, declare
under our sole responsibility that the product
(with name, type and serial number, see front
page) is in conformity with the following UK
Regulation(s):
S.I. 2008/1597, S.I. 2012/3032, S.I. 2016/1091
Designated Standards applied:
EN 61000-6-2:2005, EN
61000-6-4:2007+A1:2011, EN 61010-1:2010,
EN 61010-2-201:2013, EN 61326-1:2013
Authorities can request relevant technical information from:
Aleksandra Duric, Product Compliance Manager, Atlas
Copco Industrial Technique AB, SE-105 23 Stockholm Swe-
den
Stockholm, 21 November 2022
Carl von Schantz, Managing Director
Signature of issuer
Authorised Representative UK
James McAllister, General Manager
Atlas Copco Ltd
Swallowdale Lane
Hemel Hempstead
Hertfordshire HP2 7EA
Regional Requirements
WARNING
This product can expose you to chemicals including lead,
which is known to the State of California to cause cancer
and birth defects or other reproductive harm. For more
information go to
https://www.p65warnings.ca.gov/
Safety Information
3
