Idiomas disponibles
Idiomas disponibles
5. Verify that the on/off switch is in the 'O' OFF position before plugging the power cord into the
outlet. Plug the power cord into the outlet (Fig. 7 & 8).
the 'I' ON position (Fig. 9).
power cord from the outlet (Fig. 10).
NOTE: Make sure that the detachable blower is replaced properly onto the collection tank lid when
2
EMPTYING THE COLLECTION TANK
WARNING:
BEFORE REMOVING THE POWERHEAD FROM THE COLLECTION TANK.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Disconnect the hose from the vacuum (Fig. 2).
3. Undo the latches and remove the powerhead from the collection tank (Fig. 3). Place the
powerhead on a soft, clean surface upside down.
4. Clear all dirt or debris from the collection tank and hose into a proper waste container (Fig. 4).
6. Check the hose, accessories, and power cord to ensure that they have not been damaged.
7. Place the powerhead back onto the collection tank and secure latches.
IMPORTANT!
THE CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used without the cartridge
NOTICE!
tears; replace it immediately.
2
CLEANING THE BLOWER INTAKE
After using the blower, examine the bottom of the blower for debris and blockages and remove if
found. To clean the foam pad of the intake:
MAINTENANCE
3
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET
3
4
4
5
12
ALWAYS USE
