HealthSmart SafeStep 599-7002-0000 Manual De Instrucciones

Instructions
SafeStep Multi-Purpose
TM
Motion Sensor Light
Item # 599-7002-0000
Components
– Motion Sensor Light (1)
– Screws (2)
– Anchors (2)
– Double-Sided Tape (1)
Before You Mount Your Light
1. Unscrew the two screws on the back of the unit to
remove the rear cover, Fig. 1.
2. Once the cover is removed, switch the auto shut-off to
20 seconds or one minute, Fig. 2. Setting the auto
shut-off to 20 seconds will extend battery life.
3. Insert or replace three 'C' batteries into the
compartment, matching the indicated polarity
symbols, Fig. 3
4. To close, match up and connect the bottom hooks of
the cover, then push the top end. Tighten the screws.
Mounting Your Step Light - Indoor or Outdoor
1. Determine location for the light. Remove rear cover
and flip upside down against the wall. Use the holes
for thumb screws to mark two holes for anchors and/
or screws, Fig. 4.
Note: If mounting on a vertical surface, mount the
screws parallel to the ground. Make sure screws are a
precise distance from each other as defined by the dis-
tance of the thumb screws.
2. If using anchors, use a 3/16" drill bit to drill holes and
insert anchors. Drive the screws into the anchors so
the screw head protrudes 1/8" from the surface.
3. If using screws only, use 1/8" drill bit to drill holes and
insert screws so the head protrudes 1/8" from the
surface.
4. Slide the step light down so the screws are held
securely by the track, Fig. 5.
Mounting with Tape – Indoor Only
1. Attach double-sided tape to the back of the light.
2. Attach the light to the wall.
Toll-Free Customer Care Help Line: 800.622.4714
Monday – Friday 8 a.m. to 6 p.m. EST
Fig. 1
Fig. 3
WARNING:
• Use only new alkaline or lithium C cell batteries with
1.5V rating. Do not mix old and new batteries. Install
batteries with polarity in correct position.
• Follow battery instructions for proper disposal and
cautions.
• Mount fixture securely with included screws and use
anchors if not securing to solid wood or other solid
material.
• Step light is equipped wiht a light sensor at the
bottom of the unit, do not cover the bottom of the
unit.
Fig. 2
Fig. 4
Fig. 5
Manufactured for:
Briggs Medical Service Company
1931 Norman Drive
Waukegan, IL 60085
#910-7002-0000 06/11
© 2011 Briggs Medical Service Company