Idiomas disponibles
Idiomas disponibles
a. To activate the reminder function press button A - the display will show ON
or on.
b. Two seconds later, press the button ▲ or ▼, to set the reminder time only
when the display screen is flashing. The default reminder time is 45 minutes,
which is displayed as ⁻̱ 4 5. Then press any button to save the time setting or
wait 5 seconds for the system to save the time automatically. During the
countdown, each operation will restart the clock. When the countdown is
over, the display will show -̱ 0 0 message and the buzzer will sound a 10-
second beep.
c. During the 10-second reminder signal, press any button to reactivate the
countdown of the time that was set (at point b). If no action is taken during
the 10-second reminder signal, another reminder signal will sound after 5
minutes. No action during the second signal will turn off the position change
reminder function.
d. To deactivate the position change reminder function, press and hold the A
button for three seconds. The LED display will show OFF or oFF.
• Anti-collision sensitivity setting:
a. To set the anti-collision sensitivity, press and hold the ▲ and ▼ buttons
simultaneously for 5 seconds. There are 4 levels available (A-3, A-2, A-1, A-
0).
b. Marking of anti-collision sensitivity on the display: A-0 - the anti-collision
sensitivity function is turned off, A-1 - low sensitivity, A-2 - medium
sensitivity, A-3 - high sensitivity. The factory default setting is A-3.
c. When adjusting the height, when the desk top comes into contact with
another object, it will stop immediately and retract to avoid damage.
d. Press and hold the ▲ and ▼ buttons simultaneously for 5 seconds. If the
above code does not appear on the display, the anti-collision function is
inactive.
• Reset:
a. When the LED display shows ASꓩ or rSt, press and hold the ▼ button. The
desk top will move to the lowest or highest position and then move in the
opposite direction until it stops. The display will show the height number,
then release the button ▼. After resetting, you can use your desk as normal.
b. When an error code is displayed, briefly press the ▼ button to go to the state
ASꓩ or rSt, and perform the reset operation (as in step a).
c. If your desk still does not function properly after completing the steps above,
please contact Customer Service.
3.4. Cleaning and maintenance
a)
Before each cleaning, adjustment or replacement of accessories, and also
when the device is not used, disconnect the mains plug and let the device cool
down completely.
