Idiomas disponibles
Idiomas disponibles
EN WIRELESS BUETOOTH CEILING SPEAKER KIT - User Guide
Warnings
1. All mains electrical wiring should be carried out by a
fully qualified electrician and tested regularly
during installation.
2. All electrical work carried out in England and Wales
must comply with Part P of the Building Regulations.
If you are located elsewhere check local Regulations.
3. Always ensure electricity is switched off at the
consumer unit before any wiring work is started.
4. If the Bluetooth module is installed in a bathroom
ceiling space you must use a suitable ceiling
mounted pull cord switch or a wall mounted ON/OFF
power switch positioned outside the bathroom.
5. The Bluetooth module is designed to be mounted in
the ceiling space, always make sure there is sufficient
space surrounding the unit (a minimum of 15cm) to
allow sufficient ventilation.
6. Before drilling or cutting into ceiling or walls it is
recommended you use a suitable detector to check
for hidden cables and pipes.
7. If the speakers are to be mounted in a ceiling with a
room(s) above, in most instances, each speaker
will need to be fitted with a fire hood (not supplied).
Please check local Building Regulations.
8. Do not disassemble or modify the speaker or BT
module there are no user serviceable parts.
9. Do not mount the speakers or module close to any
heat source.
10. Do not mount the speakers in the ceiling of a shower
cubicle or above baths or wash basins.
Features and box contents
2 x 6W Ceiling speakers
1 x Bluetooth prewired receiver module -
with 2 x 3m speaker cables and 25cm power lead
1 x User guide
Introduction
You can install this kit into your ceiling for easy and safe
music listening in any room you choose. It is simple to
pair with any Bluetooth enabled device such as a smart-
phone or tablet, and minimises the risk of water damage
to your expensive electronics. Perfect for kitchens,
bedrooms and bathrooms.
The prewired compact Bluetooth module is fitted in the
ceiling space and can be connected to an existing
lighting circuit.
The speakers are very low profile and when mounted sit
almost flush with the ceiling. They are fitted in the ceiling
in much the same way as downlights and fit into cut
outs the same size as most downlights for a simple and
discrete solution.
EN
2
BLUETOOTH CEILING SPEAKER - User Guide
Positioning and planning the wiring of the
Bluetooth module
There are three methods for connecting the Bluetooth
module to an existing 6A lighting circuit.
Bear in mind you need to position the module within 3m
of both speakers if you want to use the
prewired speaker cable to reach the speakers in their
mounted position.
1. Wiring to an existing lighting rose if there is sufficient
terminal space. Please note this method should
only be used if you want the Bluetooth module pow-
ered only when the lighting is switched on.
2. Wiring a new junction box into the lighting circuit.
This method requires running a new cable to an
on/off light switch.
3. Wiring to an existing Wago type junction box in the
lighting circuit. This method requires running a
new cable to an on/off light switch.
Positioning and wiring a power ON/OFF
switch for the Bluetooth module
There are a number of options for positioning an
ON/OFF switch.
1. Running a cable from a ceiling junction box to a new
wall mounted switch or ceiling pull cord switch.
2. Running a cable from a ceiling junction box to an
existing switch position and replacing a single light
switch with a twin lighting switch (or replacing a twin
switch with a triple switch).
N.B. We have supplied a transparent label with a
speaker symbol to mark the switch used for the speaker.
www.philex.com/support
