Idiomas disponibles
Idiomas disponibles
Before transmission between your BT device and the radio is possible, both devices must be coupled. This process is called
"pairing". The radio is served as a receiver, to receive the music stream to be played on the radio. If you have already coupled
to a BT device before, this connection will be restored automatically when both devices are in range and BT operation has
been selected on the radio. "Pairing" does not have to be repeated. This function may need to be activated in your BT device,
however.
• Press [BT select] to enter BT mode.
• Turn on BT streaming on your device. The device will scan for pairable BT devices in the reception range.
• Select "Audizio AD Amplifier" from the list with found devices.
• Start playback on your BT device. Playback now takes place emitting sound from the radio.
You can listen to the music stored in other audio device or smart phone via the radio, through the connection to the 3.5 mm
aux-in jack on the rear side. Use a cable with 3.5 mm pins at both ends, one end connected to the aux-in jack on the radio, the
other end connected to the earphone jack on the audio device (or line out socket if available). Press [AUX select].
Play music on the connected device, the sound will be emitted from the radio.
1. MP3
Press to put the turn on/shut off the MP3 module
2. A
No function for this device
3. B
No function for this device
4. Volume
Press to increase or decrease the volume level
5. Track selection
Press to go to previous- or next track
6. Play/pause
Press to (re)start/pause play
7. Input
3 choice button. Press to switch between AUX, LINE and DVD input modes
8. Opt
No function for this device
9. Coa
No function for this device
10. Blue
Press to switch to BT input mode
6
