Idiomas disponibles
Idiomas disponibles
LIGHTING YOUR PLANCHA
1. Open the lid before lighting.
2. Connect the gas cylinder to the plancha following the instructions supplied with the
regulator.
3. Turn all the control knobs to the 'OFF' position.
4. Turn 'ON' the gas supply at the cylinder or regulator switch following the regulator
connection and operating instructions. Check the cylinder to regulator connection and
hose to plancha hose inlet connection for leakage using soapy water. Any leakage will
show as bubbles in the area of the leak. If leak is found, do not use the plancha. Consult
your gas or plancha supplier for advice.
5. To light the left hand burner, push down and turn the left burner control knob anti-
clockwise to the 90° position (full rate position). An audible click will be heard, this should
light the burner. Check that the burner is alight. If the burner has not lit, repeat this
process.
6. If the burner has not lit after two attempts, turn 'OFF' the gas tap and wait 5 minutes
before retrying the ignition sequence.
7. When the burner has lit, the burner rate can be adjusted by push down and turn the
knob anti-clockwise to any position between the full and low rate position.
8. Light the right burner repeat above process.
9. To turn 'OFF' the plancha, turn the cylinder valve handle or regulator switch to the 'OFF'
position by following the regulator instructions. Once the burners have extinguished turn
all the control knobs to the 'OFF' position.
Warning: If any burner fails to ignite, turn the control knob off (clockwise) and also turn the
cylinder valve off. Wait five minutes before attempting to relight with ignition sequence.
After use, close the gas supply by either turning 'OFF' the switch on the regulator or turning
'OFF' the cylinder valve.
In the event of light back whilst the appliance is in use. Turn all the controls, cylinder valve
and regulator switch to the 'OFF' position. Wait 5 minutes before attempting to relight the
appliance. If the problem persists after relighting, consult your gas dealer, or the store where
you purchased the plancha, or a qualified gas engineer for assistance or repair. Never try to
rectify the problem yourself as this could result in serious injury and/or property damage.
Clean the appliance of excess fat, before storage, with a damp cloth using a mild detergent
solution as the cleaning agent.
Store the appliance in a clean dry environment.
Do not store your gas cylinder indoors. Store in a well ventilated area away from direct
sunlight.
37
