Connecting The Condensate Drain Pump (Option) - CIAT COADIS LINE 600 Manual De Instrucciones

4.5. Connecting the condensate drain pump (option)

The condensate drain pump can be supplied mounted on the unit as an option.
Its technical specifications are as follows:
- Maximum flow of 8.5 l/h for a head height of 2 metres and a maximum pipe length
of 5 metres.
- Maximum flow of 7 l/h for a head height of 4 metres and a maximum pipe length
of 5 metres.
The operation points are provided in the table below.
Connect a clear drain pipe (not supplied) with an internal diameter of 6 mm between
the pump outlet and the wastewater pipe.
Table of actual flow rates for the DE05UCC pump with Ø 6 mm PVC internal pipe:
Discharge
height
1 m
2 m
3 m
4 m
Under operating conditions outside the recommended temperature and relative
humidity range (page EN-2), the discharge pipe must be insulated to prevent
condensation, which could damage the installation and the pump. We recommend
using a transparent colourless PVC type pipe with internal diameter 6 mm/external
diameter 9 mm. It is essential to ensure that the pump connections are sealed. A
clamp can be used for this purpose.
Important: Check the unit selection data to determine the maximum condensate
flow rate.
Note: This accessory must always be used with a valve control device, to ensure
valve control of the high safety device when the valve is closed (closure of the
condensate drains).
TABLE OF ACTUAL FLOW RATES (l/h)
Total pipe length (internal Ø, 6 mm)
5 m 10 m
10.4 9.1
8.5 7.8
7.9 7.1
7 6
EN - 9
20 m 30 m
8.3 7.3
7 6.4
6.3 5.8
5.3 4.9
EN