Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS (Continued)
4.
Insert the hose from the side spray assembly (B)
down through the sprayer support (C) and sink until
the spray head (4.1) rests in the top of the sprayer
support (C).
Underneath the sink, remove the hose connection
cap (D) from the faucet body (A). Attach the side
spray (B) hose to the hose connection (4.2) at the
bottom of the faucet body (A) by tightening the swivel
nut (4.3) by hand, then use pliers (not included) for
1/4 extra turn. Be careful not to twist the hose or
overtighten the swivel nut (4.3).
Skip to Step 6.
5.
If not installing the side spray, ensure the hose
connection cap (D) is securely attached to the hose
connection on the bottom of the faucet body (A). If
needed, gently tighten the hose connection cap (D)
underneath the sink. Do not overtighten.
6.
Attach one end of each of the water supply lines onto
the shanks (6.1) on the faucet body (A), with hot water
on the left and cold water on the right. Use 1/2 in. IPS
faucet connections (6.2) or supply line coupling nuts
(6.3) with 3/8 in. OD ball-nose risers (6.4). NOTE: Do
not reuse existing supply lines. When installing new
water supply lines, please refer to the supply line
manufacturer's installation instructions.
Tighten the supply line connections using an adjust-
able or basin wrench. Do not overtighten.
4
5
6
5
A
D
6.2
6.3
6. 1
6.4
