Idiomas disponibles
Idiomas disponibles
Installation and Mounting
Carefully examine the unit for damage before installation. If
damage is found, contact the transit company or ECCO. Do
not use broken or damaged parts. Prior to mounting, consider-
ation should be given to cable location. The mounting location
should be chosen such that there is maximum visibility to the
oncoming traffic.
Bracket Mounting:
1.
Select a mounting location for the unit on a flat surface.
2.
Secure the light head with the supplied hardware as
shown in Figure 1. Adjust the beam angle as needed
before ensuring all hardware is tightened.
iming Instructions:
A
Installer is responsible for ensuring the headlights are aimed
properly such that beams comply with current highway regula-
tions. Beams should project the same distance ahead as
compliant OEM headlights.
Wiring Instructions
The wiring configuration is as shown in Figure 2. Use the supplied
mating connector All wiring should be a minimum of 16 AWG. The
positive line must have a slow blow 25 amp fuse. Routing the ground wire directly back to negative battery terminal is recommended. Pack
dielectric grease, such as Dow Corning 4, around each electric connection exposed to moisture or the ambient environment.
Ground (-) (Black)
High Beams (Red)
Low Beams (Yellow)
Parking Light (Grey)
Indicator Light (Green)
Loosen on both sides
to adjust beam angle
MOUNTING SURFACE
Image shown: EZ4009-R. Ensure LEDs reflect onto the roadway.
IMPORTANT! Disable power before wiring the product.
20A In-Line
Fuse
FIGURE 2
FIGURE 1
Ignition
+
-
Switch
Page 2 of 3
