Idiomas disponibles
Idiomas disponibles
5. CONNECTION TO THE MAINS
1.
Ensure that mains voltage and frequency are the same as those stated on the rating plate
to the appliance.
2.
Ensure that the supply socket has the following characteristics:
earthed. b) It fulfils the requirements of the rated current as set out on the rating plate. c) It complies with
the IEC regulations: - Magnetothermal differential switch (also known as ground fault interrupter) with In =
nominal value as stated on the rating plate; - Differential with Id sensitivity = 30 mA.
is no danger of explosion (AD) in the room.
designed for internal use. For installation in any other environment, it will be necessary to change the
cable with the appropriate type (for example H07 VVF for external use).
inside the tank. . Insert the jack of the cable into the plug. . Insert the plug on the other end of the cable
6
into the power supply socket (do not use three-way adapters and reduction adapters). . Switch on the
refrigeration switch under the motor compartment and wait for the green light to come on.
the appliance, pull the plug out of the socket, after first turning off the special switch.
transport or storage the appliance has been placed by mistake in a horizontal position or has been turned
upside down, leave for at least three hours in the correct position before switching on the power supply
(see figure 4).
6. CONTROLS
The appliance is equipped with adjusting controls in a small protected panel located on one side of the
cabinet.
1. Refrigeration unit switch:
for checking the temperature inside the appliance. a) Press button
temperature set-point,which can be changed by pressing button
switch: to switch on the internal lights.(see figure 5)
7. CHECKING CORRECT OPERATION
CHECK THAT: 1. the jack on the power supply cable is correctly inserted into the plug on the cabinet.
2.
The refrigeration unit switch is switched on (green light on). . The thermometer shows the desired
temperature for the goods to be stored. . The appliance is not exposed to direct sunlight or to high-
powered lamps. . The room temperature does not exceed that in which the appliance is designed to
5
work normally, i.e. +30°C, 55% r.h. (climatic class 4).
8. INTERNAL CLEANING
1.
Switch off the appliance.
3. Defrost the evaporator and collect the resulting water in a container, which must be disposed of
4
accordingly. . Wipe the walls and accessories of the appliance with a sponge dipped in water with a little
sodium bicarbonate. Dry with care (see figure.6).
Operator's guide
4.
The connecting cable to the appliance is H05 VVF,
to switch on the refrigeration unit.
4
2.
Remove all goods, placing them in an adequately refrigerated place.
9
a) It is properly
3.
5.
Take the supply cable stored
7
2. Thermometer / Thermostat:
3 "SET or P"
once to display the
4"UP"
5"DOWN". 6 Light
or button
3
(A)
attached
Ensure that there
8
9.
To turn off
N.B.
If during
.
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO
