Idiomas disponibles
Idiomas disponibles
Set Up The Programming Card
Default
Before setting the programming card, it is allowed to
use the default pin code (123456#) and any
cards/tags to unlock. After completing the setup of
the programming card, the default pin code
(123456#) will be invalid.
The Programming Card must be linked to the lock
before any other steps can take place.
Note
If 2 short beeps occur with the red light flashing 2 times,
the setup was not successful. Please re-program.
1
Tap the programming card on the reader, the red light
will start flashing for 10 seconds until "1 long beep
sound" followed by the green light flashing 3 times.
Red
Green X 3
Note
1. Within these 10 seconds, do not remove the
programming card away from the reader.
2. Programming card is used to add/delete user cards/badges,
but not be used to unlock the cylinders.
3. Any MIFARE card will be able to unlock the cylinder
before it is programmed.
4. There is only ONE programming card per cylinder.
Please keep it safely.
5. You can use one programming card for multiple cylinders.
10 "beep" sound
1 "beep" sound
Lock Setup with App
Follow below steps to get your lock setup with
WAFERKEY App. You can also use the mobile
App to set up your lock step-by-step and access
installation videos.
1
Download the App by
searching "WAFERKEY"
in the App Store (iOS) or
on Google Play (Android).
2
Open the App, simply use a Third Party Login
or register a WAFERKEY account.
3
Make sure the lock has been already
programmed by the programming card.
Turn on Bluetooth on your smartphone,
stay near the lock and follow the instruction
in the App.
4
Pair the lock in the App and start to use it.
Note
1. The WAFERKEY App works on iPhone with iOS
13.6 or later, or devices with Android 8.0 or later.
2. Be sure to accept any available firmware update.
3. Please refer to the instruction in WAFERKEY App
for more information.
4. Once the lock turns to App Mode, ALL the existing
user access settings (Key Card, Passcode ...)
will be deleted.
DON'T WANT TO USE THE APP?
Please go to Standalone Mode page for manual
programming instructions.
Questions about your new lock?
Let us help you!
