Control Elements - TECshow LINK WI-R Manual De Usuario

5. CONTROL ELEMENTS

Link Wi-T Front & Rear views
Link Wi-R Front & Rear views
1. Audio input connector: These jacks cab be
used to connect the input signal, and with XLR
and 1/4" jack.
2. Antenna for transmitter: Send the signal by
antenna. To receive the signal better, please
make sure the antenna was not sheltered.
3. Status indicator: Working mode: Both of Link
Wi-T and Link Wi-R LED light on. Stand by mode:
The LED indicator of Link Wi-T lighted on and
Link Wi-R flash 1s/1s on/off. Pairing Mode: Both
of Link Wi-T and Link Wi-R LED flash 0.5s/0.5S
on/off.
4. Pair: Pairing key for Link Wi-T & Link Wi-R:
• Push down and hold pair switch of Link Wi-T
more than 3 second to enter into pairing mode,
status LED lighted on 1 second then flash
0.5s/0.5s on/off. Then push down and hold pair
switches of Link Wi-R more than 3 seconds to
make Link Wi-R enter ito pairing mode, status
LED flash 0.5s/0.5s on/off. At the time of pair-
ing, Link Wi-R with short beep sound. If pairing
success, a long beep sound will be heard and
the LED will be lighted on (To pair successful,
please make sure only one Link Wi-T for pairing
to avoid interferng).
• If pairing fail, Link Wi-T & Wi-R will still keep on
pairing mode for 15 seconds. After 15 seconds,
they will return Stand by mode and you can pair
again by pressing the pairing switch.
• If pairing success, Link Wi-T & Wi-R can connect
automatically after powered on.
5. Stereo/Mono: Shift Link Wi-T working mode.
When press the key, L input and R input will
work in Mono mode, both the signals mix
| Tecshow Link WI-R & WI-T
English version
P. 7