Idiomas disponibles
Idiomas disponibles
ASSEMBLY
PUSH HANDLE
8
•
Insert the push handle
into the rear of the walker
(Fig. 8).
NOTE: Push handle
is not removable after
assembly.
TRAY INSERT
9
•
(1) Align the tabs and
feed them through the
holes on the top tray.
(2) Press on the back
of the insert to make
the insert click into
place (Fig. 9a)
• When facing the
walker, remove the
tray insert by pulling
the corner tabs toward
your body first, then
pull up to release
(Fig. 9b).
11
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Fig. 8
2
"Click"
1
Fig. 9a
Fig. 9b
TOY ATTACHMENTS
10
•
All toys must be
aligned with their
single tab housings
on the tray (Fig. 10).
Set the toy base
in alignment with
the tabletop fitting.
From underneath the
tabletop push the lock
up and turn it left
to lock.
• Toys must be properly
attached before use.
NOTE: ONLY
standalone toys are
interchangeable for
the tabletop.
• Use the diagram below to lock the toys onto the
tabletop. (1) Push the tab up and rotate it left to lock.
(2) Rotate the tab right to release the toy. (3) Always
put the small tab lock back into the tabletop when not
in use.
Align
1
2
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
ASSEMBLY
Fig. 10
3
12
