PNI Duplex 2000 CB-FM antenna
Multi-band mobile antenna that combines CB and FM frequencies.
Made of quality materials, the PNI Duplex 2000 antenna guarantees the best
performance, allowing the simultaneous use of both the CB transceiver and
the FM radio equipment.
Technical specifications
Frequency range
S.W.R.
Maximum power
Impedance
Polarization
Spike length
Material
Cable
Connectors
Mounting hole diameter 16 mm
Installation
•
Drill a 16 mm diameter hole in the car body.
•
Unscrew the hex nut below the antenna mounting base.
•
Pass the short connecting cables through the previously drilled hole.
•
Carefully tighten the hex nut on the antenna thread by means of a suitable
tool with a tightening torque of up to 3 ÷ 4 Nm to prevent thread damage.
•
Guide the two RG174 cables (5 meters) close to the CB transceiver and
the FM radio. Avoid damaging, pinching, twisting or flattening the cables.
•
Connect the PL259 connector to the CB transceiver and the ISO male
connector to the FM radio.
•
Tune the antenna only if necessary. The antenna comes factory-tuned. For
tuning, call a specialist service center.
User manual
26.965 - 27.405MHz (CB)
87.0 - 108.0MHz (FM)
≤ 1.2
50W (continuous)
50 Ohm
Vertical
440 mm
Fiberglass
RG174 5m (CB) / RG174 5m (FM)
PL-259 (CB) / ISO male (FM)
2