Idiomas disponibles
Idiomas disponibles
4. Start-up
Remove the device from its packaging and remove all packaging material. When
the unit is put into operation for the first time, check again that the product or
components are undamaged and that they function properly. Place the unit on
a flat surface. Now connect one or two hard disk drives to the designated con-
nectors. Connect the supplied USB connection cable to the back of the docking
station and to your computer or notebook. Connect the 12V power supply to the
docking station and then to a properly connected power outlet. Then press the
"Power" button on the back of the device. The docking station is then ready for
operation.
5. Clone function
Note: The hard disks can get hot during the clone process.
Make sure that the destination hard disk has at least the same size as the hard disk
to be cloned. The destination disk will be completely deleted at the start of the
operation. Please back-up your important data beforehand, if necessary.
Note: Please make sure that the USB 3.0 cable is not connected to your computer
or laptop during the period of cloning.
The hard drive (source) to-be cloned should be plugged into one bay "HDD 1" and
the destination disk into "HDD 2". Turn on the device with the "power" button on
the front.
Press twice in rapid succession the "clone" button on the front of the device
until the clone processing indicator starts flashing (from left to right: 0-100%).
The cloning will start and the LED display shows the cloning process. The cloning
process is completed if the progress indicator reaches 100% and stops flashing.
After a successful "clone" operation, you can connect the docking station to your
computer again. In few cases just one hard disk might be recognised because it
both have the same names and data.
You can assign drive letters manually, by searching for "Computer Management",
opening it and then navigating to "Disk Management". Perform a right-click on the
desired drive and select "Change Drive Letter and Paths...".
8
English
