Idiomas disponibles
Idiomas disponibles
Connect the mouse to the recorder by
plugging the mouse USB connector into the
USB port on the back or front panel. The
mouse is immediately operational, and the
pointer should appear.
Web browser control
The recorder's web browser lets you view,
record, and play back videos as well as
manage all aspects of the recorder from any
PC with internet access. The browser's easy-
to-use controls give you quick access to all
recorder functions. See Figure 4 below.
To access the unit, open a web browser and
enter the IP address assigned to the recorder
as a web address. In the logon screen, enter
the user ID and password.
Install the recorder web plug-in to see live
camera images (Internet Explorer only).
Figure 4: Web browser interface (live view
shown)
The default values for recorder network
settings are:
•
DHCP: Disabled by default.
•
IP address - 192.168.1.82
•
Subnet mask - 255.255.255.0
•
Gateway address - 192.168.1.1
•
Server Port: 8000
•
HTTP Port: 80
•
RTSP port: 554
Note: The following ports need to be
forwarded in the router to connect properly:
Server port and RTSP port.
4 -EN
OSD control
The recorder's OSD does not provide full
access to all the functionalities available.
Refer to the user manual for more detailed
information.
Adding IP cameras
This section describes how to add IP cameras
to the recorder.
The process depends on the recorder type
(with/without PoE ports), camera status
(activated/inactivated), and the method used
for adding the cameras (via OSD menu or via
the webpage).
Using the recorder's PoE ports (for S
models only)
To add an IP camera via the PoE ports:
Camera is not yet activated:
1. Set up the camera password in the
recorder in web mode (see the section
"Manage camera passwords" in the user
manual for more information).
2. Connect the IP camera to one of the free
PoE ports at the back of the recorder.
3. The recorder assigns an IP address
(192.168.254.x) to the camera and will
automatically activate the camera using the
password set up in the recorder. This
process will take a couple of minutes.
4. The camera automatically connects to the
recorder. The recorder starts recording
video as soon as the camera has been
successfully added.
Camera is already activated, has a LAN
IP address, and has the same password
as the recorder:
1. Connect the IP camera to one of the free
PoE ports at the back of the recorder.
2. The recorder assigns an IP address
(192.168.254.x) to the camera and will
come online. This process will take a
couple of minutes.
3. The camera automatically connects to the
recorder. The recorder starts recording
video as soon as the camera has been
successfully added.
TVN 12 Quick Start Guide
