Idiomas disponibles
Idiomas disponibles
Routine Maintenance
EN
Clean the Air Duct
If the air duct is blocked, please clean it according to the following
steps.
1. Unscrew mounting screws on the air duct cover and remove the
cover plate.
2. Check whether the air duct is blocked by foreign objects. If any,
clean them.
20
3. Reinstall the air duct cover as shown in the diagram.
Robot Restarting
If the robot stops responding or cannot be turned off, press and
hold down the button
for 10 seconds to forcefully turn it off.
Then press and hold the button
for 3 seconds to turn the robot
on.
Battery
The robot contains a high-performance lithium-ion battery
pack. Please ensure that it remains well-charged for daily use to
maintain optimal battery performance. If the robot is not used for
an extended period of time, turn it off and put it away. To prevent
damage from over-discharging, the robot should be recharged at
least once every three months.
Troubleshooting
Problem Type
Solution
The battery level is low. Recharge the robot on the base, then try it again.
Robot does not turn on
The temperature of the battery is too low or too high. It is recommended to operate the appliance at a
temperature between 32 ℉ (0°C) and 104 ℉ (40°C).
The base is not receiving power. Please confirm that both ends of the power cord are plugged in
correctly.
Robot cannot recharge
The robot may be in poor contact with the charging contacts. Clean the charging contacts on both the
base and the robot.
There are too many obstructions around the base. Place the base in a more open area.
Please clean the signaling area of the base.
Robot cannot return to the
Moving the robot may cause it to re-position itself or re-map its surroundings. If the robot is too far from
base
the base, it might not be able to automatically return on its own, in which case you need to manually
place the robot onto the base.
Robot is malfunctioning
Turn off the robot and then reactivate it.
Robot is making a strange
A foreign object may be caught in the main brush, side brush, or one of the main wheels. Stop the
noise
robot and remove any debris.
The dust bin is full. Please clean the dust bin and auto-empty vent.
Robot no longer cleans
efficiently or leaves dust
The filter is blocked. Please clean it.
behind
A foreign object is caught in the main brush. Please clean it.
EN
21
