Idiomas disponibles
Idiomas disponibles
The battery is equipped with LED indicators that
indicate the remaining battery life at any time by
pressing the adjacent button (P):
4 LEDs illuminated: fully charged
2 LEDs illuminated: 50 % capacity
1 LED flashing: minimum charge, the battery is
almost depleted and needs to be charged.
The electronics protect the battery from any damage
caused by complete depletion.
Continuous overload causes deactivation due to overheating. In such a case, allow the battery to cool down;
if the battery feels hot to the touch, it can be cooled down more quickly by inserting it into the relevant "AIR
COOLED" battery charger.
The battery charge status can also be seen on the display (11).
6.2) Using the battery charger
Only use the battery charger supplied following the instructions provided.
Approximately 120 minutes are required to charge a fully depleted battery.
7.1 GETTING STARTED
Always remove the battery before fitting/removing any accessories.
7.1.1) Fitting the reaction arm
Check the reaction arm before using it; do not use a damaged reaction arm.
Always ensure that the reaction arm is resting entirely on the surface during work.
During use, keep hands and feet away from the pinch point between the reaction arm and
contact surface.
15
7. INSTRUCTIONS FOR USE
17
EN
The reaction arm (16) absorbs the reac-
tion forces during the fastening, allow-
ing the tightening torque required to be
generated; it is essential to the correct
operation of the torque wrench.
16
It can be fitted in any position on the
toothed ferrule through 360° to allow
the operator to work in the most com-
fortable position:
Press the button (17) to remove the
arm or to fit it.
P
