Directions For Use; Description/Intended Use - Covidien Nellcor MC10 Instrucciones De Uso

en
MC10
Pulse Oximetry Interface Cable
Identification of a substance
that is contained or present
within the product or
packaging.

Directions for Use

This device is not made with natural rubber latex or DEHP.

Description/Intended Use

The Nellcor™ Pulse Oximetry Interface Cable, model MC10, is a 10 foot (3 meter) cable that links a
Nellcor oxygen sensor to a Nellcor or Nellcor-compatible monitor. The MC10 cable is for use with
Nellcor oxygen sensors, except for Nellcor oxygen sensors with white plugs.
Instructions for Use
Use ONLY Nellcor oxygen sensors that have one side of the connecting plug slotted. When
connecting the sensor to the cable, always orient the sensor plug so that NELLCOR is visible.
1. To connect the MC10 cable to the monitor, depress the buttons on both sides of the cable
connector as it is inserted into the monitor socket. Release the buttons after the cable
connector is firmly seated in the socket. (1)
2. Plug the sensor into the other end of the MC10 cable with the clear plastic sensor latch.
Ensure that NELLCOR is visible on the sensor plug as it is connected to the cable. Plug the
sensor straight in; do not twist. (2)
3. Snap the clear plastic sensor latch in place over the sensor plug. (3)
4. To disconnect the sensor from the MC10 cable, open the clear plastic sensor latch. Grasp
the sensor plug, and pull it straight out from the cable connector; do not twist. Do not
disconnect the sensor by pulling it out by the sensor cable.
5. To disconnect the MC10 from the monitor, depress the buttons on both sides of the cable
connector. Pull the connector straight out from the monitor socket and release the buttons;
do not twist. (1)
Identification of a substance
that is not contained or
present within the product
or packaging.
(Illustrations on page 2)
3
Protected against access
IP22
to hazardous parts with a
finger and protected against
vertically falling water drops
when sensor tilted up to 15°.