Tabla de contenido
1. PRESS FUNCTION BUTTON TO SELECT "PHON" ON
DISPLAY.
2. SET THE SPEED SELECTOR TO THE PROPER POSITION
DEPENDING ON THE RECORD TO BE PLAYED.
3. PLACE THE RECORD ON THE PLATTER, USE THE 45
RPM ADAPTOR IF REQUIRED.
4. PUSH THE LIFT LEVER UPWARD TO RAISE THE TONE
ARM FROM THE ARM PARK, AND THEN SLOWLY MOVE
IT TO THE RECORD SIDE. THE PLATTER WILL START TO
ROTATE.
5. PUT DOWN THE LIFT LEVER TO DROP THE TONE ARM AND TOUCH THE RECORD
GENTLY. PHONO PLAYING STARTS NOW.
6. PUSH THE LIFT LEVER UPWARD TO RAISE THE TONE ARM FROM THE ARM PARK, NOW
PLATTER WILL STILL BE ROTATING BUT PHONO PLAYING WILL STOP. TO CONTINUE
THE PLAYING, THE USER NEEDS TO PUT DOWN THE LIFT LEVER.
7. ADJUST THE VOLUME TO THE DESIRED LEVEL.
8. AT THE END OF RECORD, THE PLATTER WILL AUTOMATICALLY STOP ROTATING. PUSH
THE LIFT LEVER UPWARD TO RAISE THE TONE ARM AND MOVE IT TO THE ARM PARK,
AND THEN PUT DOWN THE LIFT LEVER.
9. TO STOP MANUALLY, LIFT THE TONE ARM FROM THE RECORD AND RETURN IT TO THE
ARM PARK.
REMARK: AS SOME KIND OF RECORD THE AUTO-STOP AREA WAS OUT OF THE UNIT
SETTING, SO IT WILL STOP BEFORE THE LAST TRACK FINISHES. IN THIS CASE, SELECT
THE AUTO-STOP SWITCH TO " OFF " POSITION, THEN IT WILL RUN TO THE END OF
THE RECORD BUT WILL NOT STOP AUTOMATICALLY (TURN OFF THE UNIT BY POWER
BUTTON OR SWITCH BACK THE AUTO-STOP SWITCH TO " ON " POSITION TO STOP THE
PLATTER ROTATE). THEN PUT BACK THE TONE ARM TO THE ARM PARK.
PHONO ENCODING
1. PRESS FUNCTION BUTTON TO SELECT "PHON" ON DISPLAY
2. INSERT MEMORY DEVICE (USB DRIVE, SD OR MMC CARD)
3. PRESS THE REC BUTTON, THEN USB OR SD ICON WILL BE FLASHING.
4. PRESS SKIP UP
(USB OR SD) FOR ENCODING. THEN PRESS THE REC BUTTON AGAIN TO CONFIRM.
AND THE SYSTEM IS STARTING THE ENCODING MODE AFTER FEW SECONDSS.
5. IF ONLY USB DRIVE, SD OR MMC CARD IS INSERTED, STEP 4 CAN BE SKIPPED.
6. THE "REC" WILL BE FLASHING ON THE DISPLAY DURNIG ENCODING.
7. TO FINISH ENCODING:
• P RESS STOP
AND TURNTABLE WILL STOP OPERATION. PRESS REC BUTTON AGAIN, ENCODING
AND TURNTABLE WILL RESUME TO WORK.
• P RESS AND HOLD REC BUTTON CONTINUOUSLY, "REC" WILL DISAPPEAR,
RECORDING WILL STOP OPERATION, BUT TURNTABLE WILL KEEP OPERATION.
PRESS REC BUTTON AGAIN, ENCODING WILL RESUME TO WORK.
BUTTON OR SKIP DOWN
I
BUTTON OR REC BUTTON, "REC" WILL DISAPPEAR, RECORDING
¡
EN
BUTTON TO SELECT DESIRED MODE
I
20
Tabla de contenido
