Idiomas disponibles
Idiomas disponibles
(1) Initial Start-up
When your spa is first actuated, it will go into Priming mode, indicated by "
less than 5 minutes (press "Temp" or "Set" to skip Priming Mode) and then the spa will begin to heat the spa and
maintain the water temperature in the Standard mode.
(2) Temp/Set(80°F - 104°F / 26°C - 40°C)
The start-up temperature is set at 100F°/37°C. The last measured temperature is constantly displayed on the LCD.
*Note that the last measured spa temperature displayed is current only when the pump has been running for at
least 2 minutes.
To display the set temperature, press the "Temp" or "Set" pad once.
To change the set temperature, press the pad a second time before the LCD stops flashing. Each press of the
"Temp" or "Set" pad will continue to either raise or lower the set temperature. If the opposite direction is desired,
release the pad and let the display revert to the current water temperature. Press the pad to display the set
temperature, and again to make the temperature change in the desired direction.
After three seconds, the LCD will stop flashing and display the current spa temperature.
*Note: If there is not a blower on the system, an alternate panel with separate "Up" and "Down" buttons in place of
a "Set" or "Temp" button may be used. Simply press "Up" or "Down" where a "Temp" or "Set" button press is
indicated. (Ignore the "direction reversal paragraph")
(3) JETS
1)
operation with circ pump： Press" JETS" once to turn circ pump on, and press the button again to turn
massage pump/surfing pump on. Circ pump at work cannot be turn on but massage pump/surfing pump can. The
heater and ozone work together with the circ pump. Surfing pump/massage pump at work will turn off after 15
minutes. Circ pump will work without stop, during which it cannot be deactivated from the panel, but surfing
pump/massage pump may be operated by button.
2)
operation without circ pump(equipped with two-speed pump)： ）Press "JETS" to turn pump on or off, also can
switch the pump from high-speed to low-speed. Pump in low-speed will work together with heater and ozone.
High-speed will turn off after 15 minutes. Low-speed may run automatically at times, during which it cannot be
deactivated from the panel, but high-speed may be operated.
(4) Blower (optional)
This button is used to turn the blower on and off. If left on, the blower automatically turns off after 15 minutes.
(5) Jets 2 (optional)
If your system has a pump 2 installed instead of a blower, it behaves exactly like a blower would.
(6) Light
Press the "Light" button to turn the light on and off. If left on, the light automatically turns off after 4 hours.
(7) Mode
Mode is changed by pressing the "Temp" or "Set" button, then pressing the "Light" button.
1) Standard Mode is programmed to maintain the desired temperature. Note that the last measured spa
temperature displayed is current only when the pump has been running for at least 2 minutes. "
displayed momentarily when you switch into Standard Mode.
2) Economy Mode heats the spa to the set temperature only during filter cycles. "
temperature is not current, and will alternate with temperature when temperature is current.
14
".The Priming mode will last for
" will be
" will display solid when
