Rollplay Footie Car Manual De Instrucciones página 5

EN
Manual for assembly and use:
Thank you for purchasing this ride on vehicle, we hope that the rider
enjoys it for years to come.
Please read the instruction guide carefully before using the vehicle.
Warning
WARNING
TO AVOID SERIOUS INJURY
1. Continuous adult supervision required and adult assembly only.
2. This vehicle is not suitable for children over 60 months due to
4. Never use near motor vehicles, streets, roadways, alleys, swimming
pools, hills, steps driveway, sloped driveways inclines and motor ways.
5. Only one child should ride at a time.
6. The user should always remain seated and facing forward while using
this vehicle.
7. Make sure that the child's feet are on the footrest before pulling the
vehicle.
8. Children should always wear shoes when riding.
9. Do not allow children to stand in the vehicle at any time.
10. Never ride the vehicle outside at night.
11. Never use in wet weather.
12. Maximum user weight is 25kg.
13. There are additional hazards of using the toy in areas other than private
grounds.
14. Not to be used in tra c.
15. The vehicle must be used with caution since skill is required to avoid falls
or collisions causing injury to the user and third parties.
16. Periodically check the hardware and tighten if necessary. Replace worn
or broken parts immediately.
17. Keep away from re.
18. Protective equipment should be worn.
WARNING: TO AVOID BATTERY LEAKAGE
1. Do not mix old and new batteries.
2. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel
cadmium) batteries.
3. Non-rechargeable batteries are not to be recharged.
4. Rechargeable batteries are only to be charged under adult supervision.
5. Rechargeable batteries are to be removed from the vehicle before being
charged.
6. Be sure to insert the batteries correctly and always follow the vehicle and
battery manufacturer's instruction.
7. Weak or exhausted batteries are to be removed from the vehicle.
8. Do not short-circuit the supply terminal.
Assembly Instructions
1. Screw o the bolt on the battery cover with a cross head
screwdriver and then remove the battery cover (see fig. 1).
2. Connect both connectors between the steering wheel and the
body (see fig. 2).
3.
a. Insert the steering rod into the body
b. Hold the bottom of the steering rod with hand
Then insert the connector into the hole of the body.
c. Align the holes between the steering wheel and the steering rod,
x the bolt (M5X32) and square nuts (M5) lastly (see fig. 3).
Note:
(1)Please take down the bolt and square nut before assembling the
steering wheel.
(2)Do not touch the wire when assembly the steering wheel.
4. This is the status after completely assembly for the steering
wheel. (see fig. 4).
5. Insert three 1.5V AA batteries into the battery compartment,
screw the battery cover with a cross head screwdriver (see fig. 5).
Note:
The three 1.5V AA batteries are not included. The consumer needs
to prepare these batteries.
Operating Instruction
A. The function of Steering Wheel
Function: Turn on the Power Button on the steering wheel, the
headlights start blinking for 0.5S (The power is automatically turned
o for 15 minutes without any operation)
a. Press the headlight button to turn the headlights on and press
again to turn o . It will automatically be turned o for 10
minutes without any operation.
b. ress the phone button to make a ctitous phone call and hear the
phone ringing. It will be stopped after 4S.
c. Press the accident signal button to make an emergency stop
sound. The headlights will blinking for 5S and then stop.
d. Press the left Turning Light botton and the left light will start
blinking togehter with turning lights sounds. It will be stopped
after 4S.
e. Press the Right Turning Light botton and the right light will start
blinking togehter with turning lights sounds. It will be stopped
after 4S.
f. Press Horn to make a horn sound for1S and then stop.
Shutdown: Press the ON/OFF button again, the sound and light
steering wheel is turned o , there is turn o sound and the other
buttons have no function.
B. drawing function
The hook at the front of the ride-on is designed to add a pulling
rope. Please make sure you x it strong and savely. After use
remove the rope.
Care
MAINTENANCE
1. Before assembly please check that you have all the parts, if there
are any missing parts please contact your local store.
2. Once assembled please inspect all the parts and ensure the
vehicle is working properly.
3. Please carefully clean the product occasionally and not destroy
any parts.
4. In order to keep your child safe, please inspect and maintain the
vehicle periodically.
4