Idiomas disponibles
Idiomas disponibles
3. Safety / 4. Mounting
Do not dispose of with household waste. Ensure a proper disposal in accordance with national
regulations.
4. Mounting
4.1 Mechanical mounting
Only use the pressure switch if it is in perfect condition with respect to safety.
Prior to commissioning, the pressure switch must be subjected to a visual inspection.
Leaking liquid is indicative of damage.
■
Obvious damage must be reported immediately.
■
With a high ambient temperature and a high UV irradiation, the pressure switch must be installed with additional
■
covering in order to avoid damage to the digital indicator and buttons.
For information on tapped holes and welding sockets, see Technical information IN 00.14 at www.wika.com
Mounting instructions for process connections G 1 hygienic and TRI-CLAMP
Never loosen sealed filling screws on the measuring instrument.
■
For installation, in accordance with the fitting and flange standards the appropriate fastenings, such as screws, nuts
■
or clamp rings, must be used.
For flange mounting, only use sealings with a sufficiently large inner diameter and centre them. Contact with the
■
diaphragm leads to measuring deviations.
When using a welding socket, position this so that the hole for leakage detection points downwards. Weld the
■
welding socket flush with the inner wall of the vessel and grind down. The surface roughness of the ground surfaces
must be Ra ≤ 0.8 μm. To comply with 3-A guidelines, always provide a leakage hole of min. 2.38 mm (0.09 in) at the
lowest position.
When using soft or PTFE sealings, observe the instructions of the sealing manufacturer, particularly with regard to
■
tightening torque and load cycles.
G 1 hygienic
Wetted seals from EPDM or FKM
■
Suitable for WIKA adapter system model 910.61; see WIKA data sheet AC 09.20
■
For dimensions of the appropriate process adapters and welding sockets, see WIKA data sheet AC 09.20
■
WIKA operating instructions pressure switch, model PSD-4
®
EN
7
