Idiomas disponibles
Idiomas disponibles
5. Press hidden button on your original remote (or buttons 1 and 2
simultaneously on the new models).
6. TX Multi's LED must get fixed to then move to a faster flicker. When this
happen hold the button of TX Multi where you want to learn the original
remote until the LED turns off.
7. The remote has been copied successfully.
FAAC SLH & GENIUS 868
ATTENTION: Make sure that the remote you are about to copy is a master one.
When you press any button, the LED must flash twice instead of remaining on.
1. Place the original remote you need to copy close to your TX Multi,
aproximately 2-4 centimeters distance between each other.
2. Hold TX Multi button 1 (upper-left) and, while holding it, press 3 times the
button 2 (upper-right).
3. Release both buttons and make sure the LED of TX Multi flashes slowly.
4. Press at the same time the buttons 2 and 3 in the original FAAC/Genius
remote in order to emit the master code.
5. Hold the button you want to copy until the LED of the TX Multi starts flashing
quickly.
6. Hold the button of the TX Multi you want to learn the code until the LED turns
off.
7. The remote has been copied successfully.
3. SPECIAL CLONING PROCESS:
1. If you want to generate a fixed code or to copy the fixed part of a rolling code:
hold the button 1 (upper-left) and, while holding it, press 3 times button 3
(lower-left).
2. If you want to generate a rolling code with the same serial number as the
original one: hold the button 2 (upper-right) and , simultaneously, press 3
times button 1 (upper-left) in TX Multi.
NOTE: to add the TX MULTI control to the receiver:
1. Press the "PROG" button on the receiver.
2. Press the seed button or buttons 1 and 2 on the original remote control.
3. Press the button you want to record on the TX MULTI.
4. AUTOMATIC STORAGE SYSTEM
The automatic storage system will only work when: the via radio or remote storage
are available, the memory of the receiver is not full, or if the receiver hasn't got block
system.
NEVER USE THE ORIGINAL REMOTE UNTIL THE AUTOMATIC STORAGE
PROCESS IS FINISHED
To do the automatic storage, please do the following steps:
1. Go in front of your garage door with your TX Multi already programmed.
DS058 TX MULTI
5
