Idiomas disponibles
Idiomas disponibles
seconds and turn back on.
Make sure RS485 bus terminal wiring is correct.
Ÿ
Make sure the BUS RS485 cable is not interrupted and connected with
Ÿ
either Vesta or Clavis
Check the Lapis troubleshooting procedure.
Ÿ
If the digital input does not work:
Make sure electrical wiring is correct
Ÿ
Make sure there is not voltage other than those listed in this manual that
Ÿ
damage the input.
Make sure the switch or relay or clean contact work correctly
Ÿ
Check the Lapis troubleshooting procedure.
Ÿ
If the relay output does not work:
Make sure the yellow led turns on or turns off according to the associated
Ÿ
command
Visually check that the relay contact turns the adjacent led on or off. If the
Ÿ
relay contact does not turn the adjacent led on or off, the relay is
damaged.
Check the Lapis troubleshooting procedure.
Ÿ
If the problem persists after these checks, contact your dealer or
service center.
Installation manual • ENGLISH
13
