Idiomas disponibles
Idiomas disponibles
C3-2—Rinse the wheel and the axle with water
to remove any hair and dirt. Dry and reattach
the wheel, pressing it firmly in place.
Main Wheels
C4
* Clean monthly.
Clean the main wheel with a soft, dry cloth.
Dustbin and Washable Filter
C5
* Clean every week. Filter should be replaced every 6-12 months.
C5-1—Take out the dustbin.
C5-2—Remove washable filter and empty
the dustbin.
C5-3—Rinse the dustbin with water.
Note: To prevent blockage, only use clean water without any
cleaning liquid.
C5-4—Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Note: Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
C5-5—Allow 24 hours for the dustbin and
filter to dry thoroughly and reinstall them.
Note: Purchase an additional filter and alternate if necessary.
Dust Bag Replacement
C6
* Replace as required.
C6-1—Remove the dustbin cover vertically
as shown.
C6-2—Lift the dust bag out of the dustbin
and discard it.
Note: The dust bag handle seals the bag on removal to prevent
dust leakage.
C6-3—Clean the filter with a dry cloth.
C6-4—Install a new dust bag in place along
the slot and put the dustbin cover back.
Air Duct
C7
* Clean as required.
C7-1—Unscrew the screws (10) and remove
the cover.
C7-2—Wipe the air duct and cover with a
dry cloth.
C7-3—Re-install the cover and screw it back
in place.
Robot Sensors
C8
* Clean monthly.
Use a soft, dry cloth to wipe and clean all
sensors, including:
C8-1—Dock Locator
C8-2—Wall Sensor
C8-3—Cliff Sensors
Charging Contact Areas
C9
* Clean as required.
Use a soft dry cloth to wipe the charging
contacts on the robot. Clean the dock
location beacon, charging contacts, and
electrode brushes on the dock.
Battery
The robot is equipped with a built-in high-
performance lithium-ion rechargeable
11
battery pack. To maintain battery performance,
keep the robot charged during normal use.
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
Environmental protection
description
The chemical substances contained in the
built-in lithium-ion battery of this product
can cause environmental pollution.
Before disposing of this product, remove
the battery. The battery should then be
properly recycled either through local
authorities or by providing the batteries to a
battery recycling facility.
How to remove the battery:
Note:
The following information applies only when disposing
of the robot or if the battery is no longer functioning normally.
You will be able to recognize this problem if, even when left to
charge, the robot cannot clean due to a low battery. Do not
remove the battery if you intend to continue using the robot.
1. Turn off the robot.
2. Unscrew the battery cover.
3. Remove the battery cover.
4. Press the clip to pull out the battery
connector.
5. Remove the battery.
Notes:
• Before removing the battery, make sure it is fully drained.
Do not attempt to remove the battery if the robot is
connected to the charging dock.
• Remove the entire battery pack. Avoid damaging the battery
