Idiomas disponibles
Idiomas disponibles
5. Each panel will be numbered 1D/P - 5D/P (for Regular Cab) or 1D/P - 6D/P (For
SuperCab and SuperCrew). (D = Driver Side, P = Passenger Side) Determine and
verify the exact location for each panel by holding them up to the vehicle, lining the top
edge of the panel with the bottom edge of the tape line. Panel #1 should be located
behind the front wheel. Panel #2 located on the front door and so on until you reach the
last panel located on the bed behind the rear wheel.
6. Once you verify the location for each panel, begin applying the panels by removing the
red protective film from the back of Panel #1 on the passenger side. Align the top edge
of the panel with the tape and the back edge about a 1/16" from the back edge of the
quarter panel. IMPORTANT: Do not to allow the adhesive surface of the panels to
touch the vehicle prior to being in the correct location. When aligned, press and
hold in position for 30 seconds to ensure proper adhesion. See Figure 3 for proper
alignment.
7. Remove and fold down about ½" of the red protective film from the entire top side of
panel #2. Hold the ends of the panel as you align it to the tape on the front door. When
the part is aligned to the door and the tape line, gently press the exposed adhesive part
onto the vehicle, while maintaining alignment. Slowly pull the remaining red protective
film downward until the film has been completely removed. Press the panel firmly onto
the vehicle for 30 seconds to ensure proper adhesion.
8. Repeat step 7 for the remaining panels on the passenger side, then lastly, remove
painter's tape on the passenger side.
9. Repeat steps 6 thru 8 on the driver side of the vehicle.
05/06/16 AE
Figure 2
Figure 3
Page 2 of 3
Ford Licensed Rocker Panel Kits
FRPINST
