Idiomas disponibles
Idiomas disponibles
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for lighting.
BEFORE PUTTING INTO OPERATION
CHARGING THE BATTERY (SEE FIG. A)
NOTE:
a)
Do not use any charger other than that specifically
provided for use with the equipment.
b)
If the battery pack is very hot you must remove your
battery pack from the charger and allow time for the
battery to cool down before recharging.
c)
The battery in your new tool is not charged when it
leaves the plant. Therefore it must be full charged
before using the first time.
d)
Please charge the battery to reach full or no less than
half charge before storage. If the tool will not be used
for long periods of time, charge the battery every 3-6
months.
CHARGING PROCEDURE
1)
Plug the charger into an appropriate outlet. The light
will be green.
2)
Slide the battery pack into the charger, the light
will turn to red to indicate the charging process has
started.
3)
When charging is completed, the light will turn to
green. The pack is now fully charged, unplug the
charger and remove the battery pack.
WARNING: When battery charge runs
out after continuously use or exposure
to direct sunlight or heat, allow time for the
tool to cool down before re-charging to
achieve the full charge.
Light
Red on
Green on
14
Status
Charging
Fully Charged
REMOVING& INSTALL ING THE BATTERY
PACK (SEE FIG. B1, B2)
Depress the Battery Pack Release Button firmly first and
then slide the Battery Pack out from your tool.
Slide the fully charged Battery Pack onto the tool with
sufficient force until it clicks into position.
OPERATION
1. ON / OFF SWITCH (SEE FIG. C)
Press on/off switch, the Floor Light will come on.
Press on/off switch for in Gear III, the Floor Light will be
switched off.
2. PLACING THE LIGHT (SEE FIG. D, E)
Place the work light securely in case of falling object hazard.
Use the hook and the bracket to set the light in place. You
can also use a screw to make the work light fixed on bench.
WARNING! Do not hang the work light
on any electrical power cord!
3. ADJUSTING THE HEAD OF WORK LIGHT
(SEE FIG.E, F)
The head of work light can be set in a variety of positions.
Loose the adjusting knob to make the head of work light
in place, then tighten the adjusting knob to fix the head of
work light.
WARNING! Do not put hands or fingers
between adjustable head and bracket
when positioning the work light!
4. GEAR ADJUSTMENT (SEE FIG. G)
The light has three gears.
Press on/off switch, the worksite light
Gear I
will come on.
Press on/off switch again, the light will
Gear II
be brighter.
Press on/off switch the third time, the
Gear III
light will be the brightest.
NOTE:
If you press the on/off switch in Gear III, the light will be shut
off immediately.
WARNING! Do not direct the light beam
into your eyes!
EN
