Intellinet Network Solutions IPS-08G-60W Manual De Instrucciones página 2

This guide presents the basic steps to set up and operate this device.
For specifications, visit intellinet-network.com. Register your product at
register.intellinet-network.com/r/561204 or scan the QR code on the cover.
LEDs
The LED indicators make monitoring and troubleshooting
easier. If a status LED doesn't indicate a link or activity, check the
corresponding device for proper setup and operation.
LED
Power
PoE
Link/Act
Ports
All ports on the switch support Auto-MDI/MDI-X functionality, so you can use
straight or crossover UTP/STP cables to connect the RJ45 ports to PCs, routers,
hubs, other switches, etc. Cat5/5e/6 UTP/STP cables provide optimal performance;
if a status LED doesn't indicate a link, check the corresponding device for proper
setup and operation.
• Ports 1 – 8: 10/100/1000 Mbps ports, IEEE 802.3af/at compliant, providing
a maximum of 30 watts to connected PoE devices. The total PoE budget for
this switch is 60 watts, the per-port average power distribution is 7.5 watts.
• Port 1: The designated uplink port can be used the same way as any
of the other ports, however, when port isolation (VLAN mode 1 or
2) is active, this port remains accessible from all other ports.
2 English
Status
On
Off
On
Blinking
Off
On
Blinking Valid port connection; data transmitted/received
Off
Operation
Power On
Check connection; turn power on
Port is linked to PSE/PoE device
PoE Overload
No PSE/PoE device is linked
Valid port connection
No link established
Instructions