Mark MBAR 381 IP Manual De Uso página 12

EN
6.11 CHECK THE LIGHTING INFOR MATION
1) Press the【ENTER】button in 【INFO】menu, then enter to the checking the lighting information.
2) 【SOFT 】button is for software version information.
3) 【POW】button is for the current information of power reduction. It is 100% output in normal conditions, but
80% or 50% output in over temperature protection situation.
6.12 LIGHTING SETTING PARAMETER RESET
1) Press the 【ENTER】button in 【ST L】menu, then enter to the lighting setting parameter reset.
2) Press the 【UP/DOWN】button to select 【YES】.
3) Press the 【ENTER】button to escape and save.
Illustrations ： "ADDR" "CTST" and "PROG" are not reset, the others reset to the underlined value of the word.
6.13 【PROG】SELF-PROGRAMMING PARAMETER RESET
1) Press the【ENTER】button in 【PR L】menu, then enter to the 【PROG 】self-programming parameter reset.
2) Press the【UP/DOWN】button to select 【YES】.
3) Press the【ENTER】button to escape and save.
6.14 LIGHTING PARAMETER DOWNLOADING EACH OTHER VIA DMX
CABLE
1) Press the 【ENTER】button in 【SEND】menu, then enter to sending parameter to other lightings.
2) Press the 【UP/DOWN】button to select 【YES】.
3) Press the 【ENTER】button to confirm sending.
Illustrations ：
1)Please disconnect the connection of projector and DMX console before sending the parameter.
2)The information of【ADDR】、【CAL 】can't be sent , can't be downloaded each other.
3)There will be an automatic reset of the other projectors after receiving parameter correctly.
MBAR 381 IP - 11 -
User Manual/Manual de Uso