Idiomas disponibles
Idiomas disponibles
Installation and use
4.1 Connect power
Select the appropriate power connection according to the use environment.
▶ Use built-in battery only
The device has a built-in battery installed by default. If the battery is sufficient, it
can be turned on.
▶ Use AC adapter
Connect the AC adapter and the AC power cord firmly, then connect the input
end plug of the AC power cord to the indoor power strip, and finally connect the
output end of the AC adapter to the charging port of the device.
Connected, the power indicator on the AC adapter lights up red at this time,
indicating that the power connection is normal and the built-in battery is
charging; if the power indicator on the AC adapter lights up green, it indicates
that the power supply is connected properly and the built-in battery is fully
charged.
Requirement input terminal: AC voltage is 100～240V, frequency 50/60Hz.
▶ Use the car power cord in the car
Connect the input end of the car power cord to the car cigarette lighter, and
then connect the output end of the car power cord to the charging port of the
device. At this time, the red light of the car power cord lights up, indicating that
the power supply is connected normally.
Requirement input terminal: DC voltage is DC 12～16.8V, current is 6A.
4.2.Connect disposable oxygen inhaler
Connect the flared end of the disposable oxygen inhaler tube
firmly to the oxygen outlet of the device, and wear the other
end with reference to the figure below.
1.Put on the disposable oxygen inhaler tube as shown in the
figure, adjust the vent to a suitable position, and push the
fixing ring upward after putting it on for fixation.
2.Note that the tube of the disposable oxygen inhaler should
not be kinked or blocked, so as not to cause equipment
related alarms and affect normal use.
3.If you need to buy an oxygen inhaler yourself, please
contact the equipment provider
4.Selection under guidance.
09 English
4.3. Get started
Press the power button to start the machine, use the gear button to select the
gear that suits you, and you can start to inhale oxygen after wearing the
disposable oxygen inhaler.
This device is a pulsed oxygen supply with a built-in breathing sensor. When the
user inhales, the machine will automatically release oxygen and the "breathing
signal" light will flash; when the user does not inhale, the machine will not
provide oxygen.
4.4. Shut down
If you need to stop oxygen supply during use, press and hold the "ON key"
for 3 seconds to shut down.
After use, first unplug the horn of the disposable oxygen inhaler from the
oxygen outlet of the device, then unplug the power cord port at the charging
Installation and use
English
10
