Idiomas disponibles
Idiomas disponibles
EN
ACDB-8000C PLUG-IN WIRELESS DOORBELL
Components
(1) LED indicator doorbell
(2) Pair button
(3) Volume button
(4) Melody button
Wireless control
The wireless doorbell can be operated wirelessly with
a minimum of 1 and a maximum of 32 Trust Smart Home
transmitters of your choice. For example, you can play
a desired melody using a push button. In addition, you can
also have a melody play when movement is detected and/
or when a window or door is opened. For each Trust Smart
Home transmitter you can set a separate melody to hear
exactly whether someone presses the push button or
whether a door or window is opened.
1. Place doorbell
Plug the doorbell into an indoor power outlet. If you move
the doorbell to a different outlet, the paired transmitters
will remain in the memory.
2. Select desired volume
Press the volume button to select the desired
volume level. There are 4 levels:
High, Medium, Low and Disabled (LED Only indication).
This volume level applies to all registered channels.
You can change this volume level if desired.
6
3. Select desired melody
Then press the melody button to select 1 of the
6 melodies. You can set a separate melody per transmitter
(push button, motion detector, door/window sensor)
by selecting it beforehand.
4. Pair transmitter(s) to the doorbell
A
Do not press the connect button for more than 1 second
to activate the learning mode. The learning mode will
be active for 10 seconds and the LED indicator on the
doorbell will flash slowly.
B
While the LED indicator is flashing, send an ON signal
with a Trust Smart Home transmitter to link it to
the doorbell. For example, while the LED indicator is
flashing, you can press the push button (ACDB-8000A)
to pair it
C
As soon as the transmitter has been paired, the
wireless doorbell will give 2 short beeps. The
transmitter, melody and volume are now linked to the
transmitter. The wireless doorbell is now ready for use.
The doorbell can store 32 different transmitters in its
memory. If you want to link multiple transmitters, you
need to repeat steps 2 to 4
Unpair a Trust Smart Home transmitter
A
Press the connect button for 1 second. The learning
mode will be active for 10 seconds and the LED indicator
on the receiver will flash slowly.
B
While the learning mode is active, send an ON signal
with the associated channel of the Trust Smart Home
transmitter you want to remove.
C
To confirm, the wireless doorbell will give 2 short beeps
Repeat this procedure to delete multiple transmitters.
C
.
