Idiomas disponibles
Idiomas disponibles
FN-114474
PARTS DESCRIPTION
1. Clamping ring
2. Front guard
3. Blade fastening screw
4. Fan blade
5. Guard fastening screw
6. Rear guard
7. Motor shaft
8. Shaft pin
9. Oscillation button (
10. Speed control buttons
11. Upper standing shaft
12. Lower standing shaft
13. Standing base
14. Screws and washers (4 pairs)
ASSEMBLING INSTRUCTIONS
Base and Standing Shaft Assembly
1. Attach the lower standing shaft (12) onto the standing base (13). Use screws and washers (14) to fix the shaft
firmly.
2. Insert the upper standing shaft (11) into the lower standing shaft (12), turning the upper standing shaft (11)
clockwise to tighten the connection of two shafts.
The Whole Assembly
1. Remove the blade fastening screw (3) and guard fastening screw (5) from the motor shaft (7) spindle.
2. Fit the rear guard (6) by positioning with the location pins. Secure the guard onto the motor body with the
guard fastening screw (5).
3. Place the fan blade (4) onto the motor shaft by matching the slot with the shaft pin (8). Fix the blade by
tightening the blade fastening screw (3) in a counter-clockwise direction. Check that the fan blade can rotate
freely by turning it with your hand.
4. Put the front guard (2) against the rear guard (6) and fix with the clamping ring (1). Make sure the clamping
ring is set properly at the rim of the fan guards. Tighten the screw on the clamping ring.
OPERATING INSTRUCTIONS
1.
Plug the power cord into a suitable socket.
2.
Oscillation: To make the fan head oscillate, press the oscillation button (9). To stop the fan head from
oscillating, press the button "0", and then restart the fan.
3.
The fan is switched on and off by pressing the speed control buttons, i.e. 0 = Off, 1 = Low air flow speed, 2
= Medium air flow speed, 3 = High air flow speed.
4.
Tilting Angles: By pushing the fan-guard, you can adjust the fan to the preferred elevation.
CAUTION: Press only one of the speed control buttons at a time. Permanent damage to the switch housing may
result if two or more of the buttons are pressed simultaneously.
CLEANING
1.
Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains cable
from the socket.
2.
Never immerse the appliance in water (danger of short-circuit). To clean the appliance, only wipe it down
)
- 4 -
EN
