Dupray bloom Manual De Instrucciones página 20

EN
A weird smell is coming from the
unit.
Poor performance/air cleaning
quality.
A blinking red light has appeared
on the control button.
A steady red light has appeared on
the control button and the control
button is not responding.
20
The filter is clogged.
The air purifier may be damaged,
or a foreign object may be
stuck inside.
The pre-filter may be dirty.
The HEPA filter may be saturated
with dirt.
The unit may be in an area with
very high humidity levels (above
55%). Mold may have developed
on the filters, or essential oils may
have been diffused in the area.
Unit is set to LOW speed setting.
New air may be coming
in the room.
Air flow might be blocked by
objects, furniture, wall, toys or
anything too close
to the air intake.
The room may be too large for the
unit's specifications.
Pre-filter may be dirty or HEPA
filter may need to be replaced.
After 180 days (6 months) of usage
(time is not factored in if the unit
is OFF), the filter change light will
appear, indicating the HEPA filter
must be replaced. Don't forget to
reset the filter change alert.
A critical component of the unit
has failed.
Replace the filter. (refer to page
16-17)
Immediately cease usage, unplug
and contact Customer Support for
further assistance. Do not try to
repair the air purifier.
Clean the pre-filter.
(refer to page 14-15)
Replace the filter. (refer to page
16-17)
Make sure not to use your air
purifier in an area with high
humidity or while diffusing
essential oils. Replace the filter.
(refer to page 16-17)
Select a different air speed level
by touching the control button to
increase air flow/filtration power.
Close doors and windows while
using the air purifier.
Leave at least 12 in./30 cm
of clearance around the unit
(including walls) to allow air to
pass properly through the air
intake around the unit. Keep all
objects away from the unit.
Use the air purifier in rooms
smaller than the recommended
size : 1,517 sq.ft./141 m2.
Inspect/clean pre-filter. (refer to
page 16-17) Inspect and replace
the HEPA filter if necessary.
(refer to page 16-17)
Replace the HEPA filter if
necessary. (refer to page 16-17)
Reset the filter change alert (refer
to page 17) by selecting the filter
change mode, located right after
HIGH fan speed and hold the
button for 5 seconds.
Immediately cease usage, unplug
and contact Customer Support for
further assistance. Do not try to
repair the air purifier.