Step 11
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (F) and lay it over your unit.
Make equal margins along all four edges of the BACK (F).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the UPRIGHTS (B and C).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
Push two FEET (23E) into the BOTTOM (E).
å
www.sauder.com/services
These holes must line up over
the UPRIGHTS (B and C).
F
414958
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(46 used in this step)
E
23E
1N
23E
Page 15
