Manuales relacionados para Truper PULA-7A3
Resumen de contenidos para Truper PULA-7A3
- Página 1 Manual Polisher 1.6 Hp 7” Power Disc Applies for Code Model 16626 PULA-7A3 PULA-7A3 Read this manual thoroughly CAUTION before using the tool.
- Página 2 Manual before Parts using the tool. Assembly Keep this manual for future references. Start Up The illustrations in this manual are for reference Maintenance only. They might be different from the real tool. Notes Authorized Service Centers Warranty Policy PULA-7A3 ENGLISH...
- Página 3 Technical Data PULA-7A3 Code 16626 Description Polisher Discs 7” Voltage 127 V Frequency 60 Hz Current 10 A Power 1.6 Hp Speed 600 - 3 300 RPM Duty cycle 30 minutes work per 15 minutes idle. Maximum 3 hours per day.
- Página 4 General power tool safety warnings WARNING! Read carefully all safety warnings and instructions listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references.
- Página 5 Safety warnings for polishers This power tool is intended to function as a polisher, read all safety warnings, instructions, illustrations and specifications provided with this power tool. • Failure to follow the instructions outlined below may • If control of the power tool is lost, the cord may be cut or result in electric shock, fire and/or serious injury.
- Página 6 Safety warnings for polishers This power tool is intended to function as a polisher, read all safety warnings, instructions, illustrations and specifications provided with this power tool. • The threaded mounting (installation) of accessories must match the spindle thread. • Accessories that do not match the installation fixtures of the power tool will cause unbalance, excessive vibration and may cause loss of control.
- Página 7 Parts Speed Speed Spindle control table lock Handle Auxiliary Polishing handle Hook and loop bonnet Spindle backing disc lock Handle Power cord protector Hook and loop Trigger Continuous backing disc switch use button Carbon brush housing cap (x2) Power supply cable Polishing bonnet Assembly...
- Página 8 Start Up Start up and operation control • Intermittent operation: Connect the plug into the power outlet. Press switch (A) to start the tool. To stop, release the switch. • Continuous operation: Connect the plug into the power outlet. Press switch (A) and block it pressing the continuous use button (B). To stop, press and release the switch.
- Página 9 Carbon brushes that are out of specification may damage the motor. For best results it is recommended to use original accessories such as Truper´s BOR-PULA-7N. Storage Neatly store the tool in a dry place and protected from dust and water .
- Página 10 Notes ENGLISH...
- Página 11 In the event of any problem contacting a Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 018-7873 to get information about the nearest Service Center. AGUASCALIENTES DE TODO PARA LA CONSTRUCCIÓN...
- Página 12 . Transportation costs resulting from compliance of this warranty will be covered by For questions or comments, call 800-690-6990. Made in China. Imported by Truper S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257 Stamp of the business.