LEGRAND ZIGBEE QdR2 Manual De Instrucciones

No: D000078 – 10/20 rev. 1
Catalog Numbers • Les Numéros de Catalogue • Los Números de Catálogo: QdR2
Country of Origin: Made in China • Pays d'origine: Fabriqué en Chine • País de origen: Hecho en China
Add Remote to Zigbee Network (QdR2 Remote)
1. In the QMotion QzHub3 App, go to Add Devices page and scan for devices.
2. Pull battery tab from the remote and press any button. (All 5 LEDs will blink when the remote is added.)
NOTE: If battery tab has already been removed, hit the Program button on the back of the remote using a paper
clip or by removing the back of the remote, followed by any button on the front of the remote.
Pairing Remote to Roller Shade
NOTE: Both shade and remote must be connected to the network before they can be paired together. The
shade must be in full UP position.
1. Press and release the Channel button to select the desired channel to pair to the shade. Each press of the
Channel button will advance to the next channel. The LED after Channel 5 is the All Shades channel. This
controls all shades paired to the remote by default.
2. Use a paper clip to press the Program button on the back of the remote. The channel LEDs will
scroll back and forth.
3. Press and release the Up button. The shade will roll down to the 25% position.
4. Tug the hembar 6-10 inches. The shade will jog and move to the Upper Limit.
Unlearn a Remote From Shade
(Shade at Upper Limit)
1. Press and release the Channel button to select the channel currently paired to the shade.
2. Use a paper clip to press the Program button on back of the remote. The channel LEDs will scroll
back and forth.
3. Press and release the Down button. The shade will roll down to the 25% position.
4. Tug the hembar 6-10 inches. The shade will jog and move to the Upper Limit.
Setting Upper and Lower Limits / Learning a New Position
1. Press and release the (Up or Down) button that will be programmed. The shade will move to the selected position.
2. Press and hold the same (Up or Down) button until the shade jogs.
3. Tug shade 6-10 inches. The shade will jog in response.
4. Adjust shade to desired position. (Manually roll shade by hand if necessary.)
5. Press and hold the same (Up or Down) button. The shade will jog when learned.
IMPORTANT
The Lower Limit Position must be set prior to using the preset positions (20%, 40%, 60%, 80%).
These positions are based on the Lower Limit Position of the shade. When learning new positions, the
button currently being programmed (after Step 2 above) will not move the shade. After Step 5 all buttons
resume full functionality.
Example 1: When learning a new Upper Limit Position, the Up button is semi-disabled. Only by pressing
the Up button 3 times will the shade move to the up position (or manually roll the shade up by hand).
Example 2: When learning a new Lower Limit Position, the Down button is disabled. The shade can still
be adjusted using the Up button (or manually roll the shade by hand).
Remove QdR2 Remote from Zigbee Network
Use a paper clip to press the Program button on the back of the remote quickly 3 times
QDR2 ZIGBEE REMOTE CONTROL PROGRAMMING
QdR2 Remote for Zigbee Network
Télécommande QdR2 pour réseau ZigBee
QdR2 Control Remoto para red Zigbee
User Guide • Manuel d'utilisation • Guía del usuario
Program
Pin Hole
Back
80%
60%
40%
20%
CH
1 3 2 4 5