AquaTerra Ventura Manual Del Propietário página 16

1. Press and hold the Light button for 5 seconds
2. Press the Light button several times until St, Ec, SL, or nt is displayed.
3. Use the Plus or Minus button to choose between the Modes.
St = Standard Mode, Ec = Economy Mode, SL Sleep = Mode and nt = Quiet Mode.
4. Wait 15 seconds to allow the exit timer to expire and store the setting.
To Program the Quiet Mode the following is required:
Once in the nt mode, press the Light button then press the Up/Down button to change the amount of time
you do not want the jet pump to come on between F2 and F1.
Message Meaning
No message on display.
Power has been cut off to the spa.
HL The system has shut the heater off be-
cause the temperature at the heater has
reached 119°F (48°C). Do not enter the
water!
AOH Temperature inside the equipment
compartment is too high 194F (90°C),
causing the internal temperature in the
control system to increase above normal
limits.
Prr A problem is detected with the
temperature probe.
OH The water temperature in the spa has
reached 108°F (42°C). Do not enter the
water!
Hr An internal hardware error has been
detected.
FLO No water flow is detected by the control
system but flow is expected.
WARNING! SHOCK HAZARD! NO USER SERVICEABLE PARTS.
Do not attempt service of the control box. Contact Customer Service at (888) 961-7727
Ext. 8440 for assistance. Follow all owner manual power connection instructions. Installation must
be performed by a licensed electrician and all grounding connections must be properly installed.
CONTROL PANEL OPERATION
DIAGNOSTIC LCD MESSAGE
Action Required
The control panel will be disabled until power
returns. Spa settings will be preserved until next
power up.
DO NOT ENTER THE WATER. Remove the spa
cover and allow the water to cool down, then shut
power off and power your spa up again to reset the
system.
If spa does not reset, shut off the power to the spa
and call Customer Service at (888) 961-7727
Ext. 8440.
Open equipment compartment and wait until error
clears.
Call Customer Service at (888) 961-7727 Ext. 8440.
Remove the spa cover and allow the water to cool
down to a lower temperature. Call
Customer Service if problem persists.
Call Customer Service.
Make sure that the jet pump is running and water
is flowing; check and clean filters; make sure water
valves are open; make sure spa has a proper water
level. If problem persists, call Customer Service.
13