Idiomas disponibles
Idiomas disponibles
ADDING BAR AND CHAIN LUBRICANT
See Figure 4.
Use Bar and Chain Lubricant. It is designed for
chains and chain oilers, and is formulated to
perform over a wide temperature range with no
dilution required.
NOTE: Pole saw comes from the factory with no
bar and chain lubricant added. Level should also
be checked after every 20 minutes of use and
refilled as needed.
Remove oil cap.
Carefully pour the bar and chain lubricant into
the bar lube reservoir.
Wipe off excess oil.
Check and fill the reservoir when quick view oil
indicator is below the second to last indicator
line.
Repeat as needed.
NOTE: Do not use dirty, used or otherwise con-
taminated oils. Damage may occur to the bar or
chain.
NOTE: It is normal for oil to seep from the saw
when not in use. To prevent seepage, empty the
oil tank after each use then run for one minute.
When storing the unit for a long period of time
(three months or longer) be sure the chain is lightly
lubricated; this will prevent rust on the chain and
bar sprocket.
STARTING AND STOPPING
See Figures 3 and 5.
To start the motor:
Hold the pole saw as shown and ensure that you
are well away from anything that may contact
the blade.
Press and hold the trigger lock-out.
Depress the switch trigger.
To stop the motor:
Release the trigger to stop the pole saw. Upon
release of the trigger, the trigger lock will auto-
matically reset to the locked position.
OPERATION
BATTERY
QUICK VIEW
OIL INDICATOR
11 — English
BATTERY FUEL
LOCK-OUT
GAUGE
BUTTON
SWITCH TRIGGER
Fig. 3
CAP
Fig. 4
