Idiomas disponibles
Idiomas disponibles
e)
Use personal protective equipment as required when operating the unit as
specified in Section 1 of the explanation of symbols.
The use of appropriate, approved personal protective equipment reduces the
risk of injury.
f)
To prevent accidental start-up, make sure the switch is in the off position
before connecting to a power source.
g)
Before switching the unit on, remove any regulating tools or keys. Any tools or
keys left in the rotating part of the unit may cause injury.
h)
The unit is not a toy. Children should be watched to ensure that they do not
play with the unit.
i)
Do not place your hands or any objects inside the running unit!
2.3.
Safe use of the unit
a)
Do not overload the unit. Use tools that are suitable for the application. A
correctly selected unit will do a better and safer job for which it was designed.
b)
Do not use the unit if the ON/OFF switch does not function properly (does not
turn on and off). Units that cannot be controlled by the switch are unsafe,
cannot operate, and must be repaired.
c)
Unplug the unit before making adjustments, changing accessories, or putting
it away. This precaution reduces the risk of accidental start-up.
d)
Keep the unit in good working condition. Check before each use for general
damage or damage to moving parts (cracks in parts and components or any
other condition that may affect the safe operation of the unit). If damaged,
have the unit repaired before use.
e)
Keep the unit out of the reach of children.
f)
Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
g)
To ensure the designed operational integrity of the unit, do not remove
factory-installed covers or loosen screws.
h)
When transporting or moving the unit from storage to the place of use,
observe the health and safety rules for manual handling applicable in the
country where the unit is used.
i)
Avoid situations in which the machine stops under heavy loads during
operation. This can cause overheating of the drive elements and consequent
damage to the equipment.
j)
Do not move, shift, or rotate the machine while in operation.
k)
Do not leave the unit switched on unattended.
l)
Clean the unit regularly to prevent permanent dirt build-up.
m) The provided value of vibration emission is measured according to the
standard measurement methods. The value of vibration emission may change
if the unit is used under different environmental conditions.
